Sole Source | Vibration Controller System

1. Title

Expansion of the DLA Land and Maritime Engineering & Technical Support Directorate Product Test Center Division, Electronics Lab, VTP.

Requiring Activity: DLA Product Test Center Division, Electronics Lab, located at Cols, Ohio. Contracting Activity: DLA Contracting Services located at Cols, Ohio.

2. Introduction

The Electronics Product Test Center (EPTC) is requesting to acquire a complete vibration system for the expansion of the battery test center capability.

3. Background

DLA is contractually obligated to complete battery first article test (FAT) within a relatively short duration of receipt. Expansion of the battery test center is necessary due to the fact of the number of NSNs being transferred to DLA as the responsible activity for FAT testing.

4. Scope

Battery PLT testing is required by contract and the responsibility for this testing is being transferred to DLA Electronics Product Test Center. Contractual obligation requires that the FAT testing is completed within a relatively short duration of receipt of the material samples.

5. Applicable Directives

None.

6. Performance Requirements

1. Contractor shall deliver equipment listed below:

a. Electrodynamic shaker

b. Amplifier

c. Cooling blower fan

d. Vibration Controller

2. Contractor shall include travel, shipping, setup and training to DLA Land and Maritime

3990 East Broad Street

Columbus, OH 43213

Building 11, Section 7

7. Deliverables

Description

ETS Solutions P/N

Electrodynamic shaker w/ specialty L-fixture M437A (shaker)

Vibration Research VR9500 controller VR9500 w/NIST calibration

ISO 17025 and/or NIST calibration certificate with data

Amplifier

IPA60L

Cooling blower fan

HP-3A

All necessary cables, hoses, accessories, etc.

misc.

**Must include shipping to DLA Land and Maritime

8. Contractor Information: please list what type of Experience, Past Performance, Certifications, and/or Scheduling Needs that are required from the Contractor

a.

Contractor will coordinate with EPTC on delivery and training dates.

9. Place of Performance

DSCC Columbus

3990 East Broad Street

Whitehall, OH 43213

ATTN: Eric Kelly

Work to be performed will take place at:

Building 11, Section 7

Room 011-I-800

POC: Larry Baas

10. Travel (if applicable)

Contractor is responsible for shipping & travel to Place of Performance listed in section 9.

11. Invoicing

Payment of invoices will be accomplished by payment through the Defense Finance and Accounting Service. Invoices will be submitted to the Wide Area Workflow system in accordance with DFARS 252.232-7003 Electronic Submission of Payment Requests and Receiving Reports and DFARS 252.232-7006 Wide Area Workflow Payment Instructions within 10 workdays after the conclusion of each training session.