Repair of NSN # 6130-01-308-6188

1.1 SCOPE OF WORK: (Three Step)For the end item the contractor shall furnish all facilities,

parts, materials, equipment and services, required to inspect and, if necessary, restore to

serviceable condition. Services to be performed will not be essential in a crisis situation. Work

consists of one of four efforts: Test, teardown, and evaluation (TT&E) only; TT&E and Minor

Repair; TT&E and Moderate Repair; TT&E and Major Rebuild.

1.1.1 TEST, TEARDOWN, AND EVALUATION: The contractor shall perform visual,

mechanical and electrical testing of the end item, reusable or replacement component

parts, and materials according to the schedule in the contract to determine the condition

of the end item. Upon completion of this task, all of the components of the end item

requiring repair or replacement will be identified by part number, NSN (if applicable),

nomenclature, and location in the assembly. This information will be reported in writing

to the Procurement Contracting Officer (PCO)/ Defense Contract Management Agency

(DCMA) Administrative Contracting Officer (ACO) and, if necessary, a category of

repair will be negotiated. The price of repair for the end item will be firm-fixed based

on this negotiated repair level If no further repair is required, the asset must be returned

in serviceable like new condition.

1.1.2 MINOR REPAIR: (FFP) Minor repair is a repair that does not require total

disassembly of the end item or replacement of major subcomponents. A minor repair

candidate typically requires external adjustments or rework in order to meet all of the

electrical specifications in accordance with the Technical Order Test Procedure and

mechanical dimensions in accordance with the outline drawing. It would include repair

or replacement of damaged or missing minor external parts as required. Test each end

item IAW the specifications for P/N’s as listed in the contract schedule. If minor repair

is initiated and it is found that, in order to return the end item to serviceable condition

that the level of repair must increase to a major repair, the DCMA Government

representative (ACO/PCO or QAR) will be notified and give the notice to proceed to the

major repair category.)

1.1.3 MAJOR REPAIR: (FFP) Defined as an end item that is beyond the minor repair

category to the extent that the end item is to be disassembled or reconstituted. This could

be due to extensive mechanical damage, extensive disassembly to access or replace

subcomponents and/or replacement of major subcomponents. As with minor repair, the

end item will be tested IAW the specifications and Technical Order test procedures to

verify correct Form, Fit, Function and Interface of the P/N’s listed in the contract

schedule.)