Repair of NSN 5895-01-106-3413

1.1 SCOPE OF WORK: For the end item, the contractor shall furnish all facilities, parts,

materials, equipment and services, required to inspect and, if necessary, restore to serviceable

condition. Services to be performed will not be essential in a crisis situation. Work consists of

one of two efforts: Test, teardown, and evaluation (TT&E) only or TT&E and repair.

1.2 TEST, TEARDOWN, AND EVALUATION: The contractor shall perform visual, mechanical

and electrical testing of the end item, reusable or replacement component parts, and materials

according to the schedule in the contract to determine the condition of the end item. Upon

completion of this task, all of the components of the end item requiring repair or replacement

will be identified by part number, NSN (if applicable), nomenclature, and location in the

assembly. This information will be reported in writing to the Procurement Contracting Officer

(PCO)/ Defense Contract Management Agency (DCMA) Administrative Contracting Officer

(ACO) and, if necessary, approval to repair will be negotiated. If no further repair is required,

the asset must be returned in serviceable like new condition.

1.3 REPAIR: (FFP) The contractor shall perform the repair or replacement of all failed parts and

components. Each end item must be cleaned, configured, refinished, and tested to meet the

original specifications of the end item. The end item shall be returned in serviceable like new

condition.

Below listed item(s) will be shipped to contractor to repair:

Item Description: Keyer Driver Assembly

NSN: 5895-01-106-3413

Part Number: 654E4660-3