One (1) 64,000 lb. G.V.W. Rated Tandem-Axle Roll-Off Truck

CITY OF CASPER
FLEET MAINTENANCE DIVISION
CITY OF CASPER
(307)235-8410
July 1, 2026 Bid #FY27002
Notice is hereby given that the City of Casper, Wyoming will receive sealed bids at the Fleet Office,
Casper Service Center, 1800 E. "K" Street, Casper, Wyoming, until 3:00 p.m., July 30, 2026 for the
following:
ONE (1) 64,000 LB. G.V.W. RATED TANDEM-AXLE ROLL-OFF TRUCK
This vehicle is to be used by the Solid Waste Division of the Public Services Department; unit must have the
minimum specifications of:
General Specifications:
It is the intent of these specifications to specify the minimum requirement for the furnishing and delivery
of one (1) 64,000 lb. G.V.W. rated tandem axle roll off truck. The unit shall have less than five hundred
(500) hours and be less than twelve (12) months old, with full factory warranty. Unit shall be delivered
complete and ready for service, as specified, and shall be equipped with all of the manufacturer's standard
equipment, as advertised, whether or not specifically mentioned in these specifications, in addition to all
other equipment and attachments specified herein.
ITEM MINIMUM SPECIFICATIONS BIDDERS SPECIFICATIONS
1. GVW 64,000 pound minimum. Certified GVW.
Severe duty application model only minimum
of 112" bumper to B.O.C
2. Wheel Shall be compatible with a 60,000Lb. 22ft
Base box, cable hoist, roll off body. Minimum
acceptable wheel base shall not be less than
269". Equipment supplied shall provide
proper weight distribution when truck is
loaded.
3. Cab to 182" minimum. Shall be compatible with a
Axle 60,000Lb. 22ft box, cable hoist, roll off body.
It shall also provide proper weight
distribution when truck is loaded.
4. Diesel Diesel engine to comply with all emission
Engine standards. 400 minimum HP; torque 1650 ft.
1

lb. minimum. With Engine Block Heater.
120-volt plug-in type 1500 watt.
DPF filter located right hand side under cab
with control auto in motion, stationary
manual inhibit & auto stationary w/PTO
engaged. _______________________
Air compressor 18.7 CFM minimum
Engine to include engine brake
exhaust brake not accepted.
Air Cleaner - Heavy-duty dry type with dial
type restriction gauge, dash mounted.
Oil Filter - Spin on full flow oil filter and
auxiliary gauge, dash mounted.
Warning System - High water temperature;
low water, low air, low oil pressure buzzer in
addition to gauges, and lights, and automatic _______________________
shutdown. Rear engine PTO effects - for rear
engine mount PTO.
5. Cooling Coolant hoses shall be silicone rubber
System including heater hoses. Heavy-duty radiator
shall be protected to minus -34 F. with year-
round coolant. An integral transmission
cooler shall be provided, if needed.
6. Transmission Fully automatic 6-speed Allison 4500 RDS.
7. Axles Front - 20,000 lbs. Capacity (minimum).
FXL20 Mack or compatible
Axle shall be standard set axle-forward for
Conventional Cab.
Notice to Bidders: Truck will be operated
with a 60,000Lb., 22ft box, cable hoist, roll
off body.
Rear - 46,000 lbs. capacity (minimum).
Driver controlled differential locks. 4.19 rear
axle ratio.
8. Springs Front - 20,000 lbs. ground capacity
(minimum). Mack Multileaf Suspension or
2

compatible.
Rear - 44,000 lbs. ground capacity
(minimum). Spring suspension equal to Mack
Camel back.
9. Tires and Front 425/65 R22.5, Bridgestone M870 on
Rims Aluminum Wheels
Rear 11R22.5, Bridgestone L320 on
Aluminum Wheels
Note: Tires and rims are to meet the required
GVW rating.
10. Brakes Front - Bendix ES165-06D Brakes or
equivalent
Rear - Bendix ES 165-07D Brakes or
equivalent.
11. Cab Two (2) man, Conventional cab, standard
hood & radiator set up, with outer grab
handles for ease of ingress and egress on both
driver and passenger sides.
Driver and passenger seat shall be an air ride,
high back, air lumbar, two position front
cushion adjustment, and modera cloth
covering.
Shall have steps into cab on both left and
right side.
Insulated rubber floor mat.
Insulated cab, roof, panels, doors, rear panel.
Safety, shatter-proof glass in all windows.
Two (2) seatbelts.
Dome light door operated.
AM/FM/Bluetooth stereo
3

Power door locks and windows
Air Conditioning-Factory Compatible with
Body Mounting
Right Hand Visibility window in passenger
Door Panel.
12. Steering Steering shall be heavy-duty power steering
with auxiliary gear.
13. Fuel Left side mounted 88-gallon minimum
Tank capacity DOT approved with shut off valve.
10-gallon Def tank. Mounted on the same
side as the fuel tank.
14. Electrical 12-volt neg. ground.
160-amp alternator.
Three (3) 1,000 CCA batteries. Mounted right
side of cab.
All LED lighting.
Two (2) LED work lights on tarp mast
Five (5) amber marker lights on cab.
Dimmer switch on steering column.
Turn signals with four-way emergency
flashers.
Three sets of keys
15. Mirrors Aerodynamic Moto Mirror Package LH &
RH Motorized, Heated, Illuminated 8"
Convex Mirrors.
16. Exhaust To be single vertical pipe with horizontal
System muffler and proper protection to prevent
burns (exhaust shield) exhaust extension
mounted on top of exhaust pipe. Exhaust
4

shall be routed to RH side of truck.
17. Gauges - Oil pressure
- Inter-axle differential lock indicator
light
- Volt meter
- Air restriction indicator on air cleaner
- Water temperature
- Transmission temperature
- Hour meter
- Air pressure (dual)
- Tachometer (electric)
- Electric speedometer/odometer
- Fuel Gauge
- Def Gauge
- All gauges shall be front serviceable.
- Light, buzzer warning on oil pressure,
high water temperature, low air
pressure.
18. Color Cab: SOLID BLACK #932844
19. Mud flaps Required behind rear wheels. Betts type mud
flap hangers and anti-spray mud flaps. Or
equal.
20. Accessory The following equipment, whether or not
Equipment considered standard, shall be furnished with
each unit:
Dual sun visors.
Chrome Sun Visor to go over the length of
the front windshield
Fire extinguisher, 10 lb. ABC dry chemical
5

type. Mounted on the truck.
Backup alarm
Hot Shift PTO
Steel Tandem Fenders
Rear Skid Plates
Outboard Supported rear rollers
Recessed Rear Bumper with Pintle Ready
Apron
18 x 18 x 48 Aluminum Toolbox
Two (2) Chrome Plated air horns, approved
lighting, reflectors, and all other standard
equipment as advertised or as required to
operate on Wyoming highways. Pollution
control and safety equipment as required to
meet Federal and State OSHA regulations. _________________________________
Heavy-duty (4-speed minimum) fresh air _________________________________
heater with floor vents and defroster vents
that direct air across entire windshield. _________________________________
_________________________________
Air conditioning (in cab). Factory installed.
Minimum 2- speed dual automatic electric
windshield wipers, with intermittent control
and windshield washer.
ALL gauges or instruments will be mounted
in the dash.
21. Miscellaneous Safety equipment and all lighting shall be as
required to meet Federal, State of Wyoming,
and OSHA regulations. The successful
vendor to supply a complete set of filters for
each unit including filters required for body.
6

22. Delivery Truck shall be delivered with a full tank of
fuel, properly blended for the weather
conditions if required.
Diesel fuel to be at least the minimum
requirements of blended #2/#1 diesel fuel
with proper additives to correspond with
climate conditions.
A copy of the order confirmation to be
provided upon completion of order. _______________________
Original title shall be provided within 30
days of unit delivery to 1800 E. K St.,
Casper, WY 82601.
Title to be made out as: City of Casper,
200 N. David, Casper, WY 82601.
23. Manuals Two (2) complete sets of operator's manuals,
two (2) sets of service manuals, and two (2)
sets of parts manuals shall be supplied or an
acceptable electronic version of the above-
mentioned manuals.
Service software and any required
cables/adapters, and/or required hardware IE:
Laptop shall be provided.
24. Warranty Specify in writing, to include all parts and
labor F.O.B. Casper, for a minimum 12-
month period.
Warranty will begin when truck is delivered
completed including checklists and the truck
is placed into service.
Body Specifications:
1. Roll off Body 60,000Lb. 22ft. box, cable hoist roll off body.
2. Hoist Rated Capacity 60,000Lb. certified
3. Main Frame 8" X 4" X 12" rectangular tubing.
7

4. Front Stop 1 1/2" steel plate minimum
5. Container Lock Shall be automatic with minimum 1 1/2"
diameter stress proof pin.
6. Lift Cylinder Shaft Shall be 2 12" solid steel
7. Rear Hinge Shaft Shall be minimum 2 1/2" solid steel
8. Cable Shall be minimum of 7/8" (6 X 37 EXWRC)
22,000lb rating
9. Cable Sheaves Shall be 10" O.D. aluminum bronze-brushed
sheaves. All interchangeable.
10. Cable Anchor Shall be minimum 4 cable clamps
11. Cable End Shall be steel casting
12. Rear Hold Down Shall be of 1" plate located for standard
containers
13. Lift Cylinders Shall be single stage 6 x 4 12 x 72" stroke. All
interchangeable w/ reeving cylinders.
14. Reeving Cylinders Shall be 7 x 3 x 80" stroke. All
interchangeable w/ lift cylinders.
15. Direct Mount Pump Shall be of the gear types 35 GPM @ 1500
RPM
16. Operating Pressure 2500 PSI
17. Hydraulic Valve Multiple stack 5-way section.
18. Hydraulic Reservoir 50 gal. 25-micron filter & screen filter
19. Outside Rollers 4" O.D. with aluminum bronze bearings
20. Working Points Shall be greaseable. Grease fitting shall be
provided at all applicable wear points.
21. Safety Stand Factory Installed
22. I.C.C. Bumper Folding, mounting factory installed
23. Fenders Steel Fenders to cover both rear axles
Fenders not to exceed the height from the
8

ground at a max of 49 inches
24. Container Length 18 foot to 22 foot
25. Controls Inside air controls and outside controls
26. Tarp Pioneer Rack SARG 4500.
27. PTO Shall be of the hot shift type for automatic
transmission
28. Installation Shall include complete installation of hoist
and all required equipment
29. Manuals Two (2) complete sets of operator's manuals,
service and parts manuals
30. Hyd Heater Hydraulic tank Heater
31. 4-work Lights 2-on the tarper facing back and 1 on the left
and right rear fender facing back
32. Tool Box 18 x 18 x 48 Aluminum Toolbox
33. Hoist up Alarm Hoist up alarm outside and Light only in the
cab.
NOTE: These forms may be duplicated.
Exceptions to any of the provisions of these specifications may be waived provided they are clearly
stated in the bid, and if in the opinion of the City of Casper, the bid complied with the intent of the
specification.
Should funding be inadequate to cover the items bid, all bids may be rejected or quantities adjusted
to fit budget amount.
All contacts should be made through Dan Coryell, Casper Service Center, Casper, Wyoming, 82601.
Phone 307-235-8410.
9

PROPOSAL FOR FURNISHING
ONE (1) 64,000 LB. G.V.W. RATED TANDEM-AXLE ROLL-OFF TRUCK
FOR THE
PUBLIC SERVICES DEPARTMENT SOLID WASTE DIVISION
Proposal from (Name)
(Address)
to furnish equipment as specified to the City of Casper, Wyoming, in accordance with
specifications dated July 30, 2026.
BID ITEM:
I. Price bid for one (1) 64,000 lb. g.v.w. rated tandem-axle chassis
as specified $____________
II. Price for one (1) Cable roll off body with an auto tarper
as specified $____________
III. Trade-in allowance for 222257
Vin # 1M2AX04C7BM009886 2011 MACK GU713 $___________
IV. NET COST TO THE CITY:
(Total Price) $___________
V. Delivery: F.O.B. manufacturer of the City of Casper's choice within ____calendar days
after award of contract by City Council.
VI. Trade in unit will be considered optional if, in the opinion of the City of Casper
authorized staff, it is found to be in the best interest of the City of Casper to do so.
VII. Extended 7-year Warranties Options for the Chassis, list all options & cost and attach a
copy of all the options. Extended warranties shall be a separate purchase.
$
$
$
$
$
$
$
$
$
$
TOTAL $___________________
Extended 7-year Warranties Options for the Body, list all options cost and attach a copy of all the
options Extended warranties shall be a separate purchase.
$
$
$
10