Notice of Intent to Sole Source - IPG Photonics Corporation (IPG) High Power Continuous Wave Lasers

This Notice of Intent is not a request for competitive proposals. This is not a solicitation or request for offers. No solicitation package is available and telephone requests will not be honored. There is only one responsible source and no other supplies or services will satisfy agency requirements.

The U.S. Department of Navy, Naval Research Laboratory (NRL) Contracting Division intends to enter into a sole source contract with IPG Photonics Corporation (IPG), in accordance with 41 U.S.C. 1901 as implemented by FAR 12.102, for the procurement and installation of high-power continuous wave (CW) lasers. This brand-name requirement is deemed available only from the manufacturer, IPG, as market research has determined that IPG is the only manufacturer capable of meeting the Government's highly specific and critical technical requirements.

This notice is being posted to meet the requirements of FAR Subpart 5.2 and DFARS 206.302-1(c)(2). A solicitation will not be posted; however, any vendor that believes it can meet this requirement may give written notification to the Contract Specialist and Contracting Officer within 10 days of the publication of this announcement. Supporting evidence must be in sufficient detail to demonstrate the ability to provide comparable items that meet all specifications. All responsible sources may submit a capability statement, proposal, or quotation, which shall be considered. However, a determination by the Government to compete the proposed procurement based on the responses to this notice is solely within the discretion of the Government.

Specifications:

- YLS-50000; Qty. 1; 50kW, CW 1um water-cooled laser system, 150 um fiber core, 25m delivery fiber length, HLC-16 connector; 3-year warranty

- CDK4SW20XXH2XAXU; Qty. 2; D85/F200 HLC-16 high power collimator

- YLR-8000-SM; Qty. 1; 8kW Single-mode CW fiber laser, 3m cable length, HLC-16 connector; 1-year warranty

- CDK5MS20XXH2XAXU; Qty. 1; D60/F200 HLC-16 high power collimator

- Installation; Qty. 1; Installation of all required parts

The 50 kW laser requirements are:

• Multi-mode beam quality of up to 15 mm*mrad beam parameter product


• Delivery fiber length of > 10 m


• Low power “alignment/guide” co-linearly propagating low power laser in the visible spectrum (400-800 nm)


• Controllable over ethernet


• Power stability
  
• Fast switching ON/OFF 10%/90%
  
• Eye safe (
  
• Water compatible chiller system


• 
  
• 
  
• 
  
• Temperature operation range up to 40C


• Collimated beam diameter of
  

The 8 kW laser requirements are:

• Single mode beam quality with M2 value of
  
• Delivery fiber length of > 3 m


• Low power “alignment/guide” co-linearly propagating low power laser in the visible spectrum (400-800 nm)


• Controllable over ethernet


• Power stability
  
• Fast switching ON/OFF 10%/90%
  
• Eye safe (
  
• Water compatible chiller system


• 
  
• 
  
• 
  
• Temperature operation range up to 40 C


• Collimated beam diameter of
  

The fibers shall be coupled to a fiber collimator that has a short enough focal length (