FY25 Replace UPS Control/ COMM Shop

FCI. Memphis, TN, intends to make an award to single responsible

entity for the removal and installation :The contractor will provide labor, equipment and materials needed to complete the project.

The contractor will complete the following:

- Shut off the main power feeds to the existing electrical panels and

utilize the Lock out Tag out procedures.

- Disconnect the current power feeds from the one (1) old

Uninterrupted Power Systems and remove them from service.

- Install the 3- position switches on the load side of the UPS

systems for ability to swap between the UPS and utility power

source.

- Install safety disconnects on the line side of the UPS systems to

allow for maintenance and or replacement.

- The contractor will provide one (1) Uninterrupted Power systems

type 9355-30 for the Communication and Control Center.

- The contractor will provide Battery cabinets type 9355-30 Part

Number: KA1512100000010

for the Communication and Control Center. The battery should

provide at least 90 minutes back up power for each UPS system.

- The contractor will disconnect current power feeds from the one

(1) Uninterrupted Power Systems and re-feed power sources to

the existing panels in each area that the UPS provides protection

for the Communication Room and Control Center.

The Uninterrupted Power Systems specifications

Qty (1) 9355-30 Model 20

AC IN: 208 VAC 4 W 50/60 HZ 3P 70 A

AC OUT: 208 VAC 4 W 50/60 HZ 3P 55 A 30KW

Configuration: KB2013100000110

PLEASE SEE THE ATTACHED SOW FOR FULL DETAILS