FLOATING BREAKWATER REPLACEMENT, BAR POINT HARBOR, KETCHIKAN, ALASKA

FLOATING BREAKWATER REPLACEMENT, BAR POINT HARBOR, KETCHIKAN, ALASKA The purpose of this project is to replace two floating breakwaters at Bar Point Harbor in Ketchikan, Alaska. Bar Point Harbor is currently protected by floating breakwaters held in place by anchor chains and anchor blocks. A small floating breakwater protects the middle entrance channel and is approximately 120 feet long and 23 feet wide. A larger floating breakwater protects the harbor and is 963 feet in length consisting of four concrete modules each 23 feet wide connected using post-tensioned wire cables. Both floating breakwaters have surpassed their estimated lifespan and need to be replaced. The project will include demolition of the existing breakwaters and replacement with new reinforced concrete float-type breakwaters. The breakwaters will be moored by chains and concrete anchor blocks. The Contractor shall comply with commercial and industry standards as well as all applicable Federal, State, and local laws, regulations and procedures. Revised 3 March 2025: Added Amendment 0001 Revised 11 March 2025: Added Amendment 0002 Revised 21 March 2025: Added Amendment 0003. Revised 7 April 2025: Added Amendment 0004. Revised 17 April 2025: Added Amendment 0005. Revised 21 Apr 2025: Added copies of Solicitation and Amendments 0001-0005 with 3 attachements to SAM.gov. All documents and attachments added were previously posted to PIEE Solicitation Module on the dates listed above.