Flagger and Barricading Services

1. The contractor shall transport and erect FAA furnished barricades along Taxiways (TWY) as shown in

Attachment 1 in between the hours of 9pm and 10pm. The contractor shall remove the barricades at locations shown

in Attachment 1 between the hours of 5am and 6am. Contractor shall provide nightly pricing rates for and total

pricing for 29 shifts (Monday nights to Friday nights).

a. Barricades used will be 10”x10”x96” low profile barricades with two mounted red lights. Barricades will be

spaced at 4’ apart. Facing of barricade must be covered with pre-attached orange and white high-intensity reflective

striping.

b. Contractor shall use, at their own expense, their own vehicles to haul barricades from project laydown area,

located along Joe Crosson Drive in El Cajon, CA, along the haul route shown in attachment 2.

c. All employees driving on the airport must have a valid drivers license and must complete a 1 hour, self-paced

training prior to driving on Gillespie Field Airport (SEE). Training will be sent by SEE Airport Operations via

email.

d. All vehicles used on the airfield must have yellow flashing lights mounted on the highest point of the vehicles and

said lights must be visible from any direction. Vehicle(s) used on the airfield must have company marking on each

side of the vehicle.

e. Barricades must be transported along the route shown in Attachment 2 – Haul Route.

f. Barricades must be weighed with water to prevent displacement. Additional sandbags and/or anchors may be

required to hold the barricades in place where exposed to prop wash or jet blast.

2. Contractor shall provide an airport flagger to safely direct traffic between the hours of 9pm and 6am. Contractor

to provide pricing on a per shift cost and for 29 total shifts (Monday night through Friday night).

a. Contractor to provide proof of a minimum of 1 year experience as an airport flagger.

b. Flagger must have a valid drivers license and must complete a 1 hour, self-paced training prior to driving on the

Gillespie Field Airport. Training will be sent by SEE Airport Operations via email.

c. Flagger vehicle used on the airfield must have yellow flashing lights mounted on the highest point of the vehicles

and said lights must be visible from any direction. Vehicle used on the airfield must have company marking on each

side of the vehicle.